Ctrlk
RegisterLogin
For the complete documentation index, see llms.txt. This page is also available as Markdown.

T650c Quick Installation Guide

This guide walks you through unboxing and setting up your T650c terminal so it is ready to take payments.

Before you begin, confirm you have all devices, cables, and accessories listed below.

What's in the Box

Cover
Item

Terminal

Description

T650c payment terminal

Image
Cover
Item

Paper Roll

Description

Thermal printer paper roll

Image
Cover
Item

Power Supply

Description

Power adapter with cable

Image

Quick Setup Guide

1

Remove the Back Cover

1

Press the cover release

Place the terminal face down and press the release button on the back cover.

2

Slide the cover off

Slide the back cover toward the bottom of the terminal and lift it away.

2

Insert the SIM and microSD Cards

Insert the SIM card into the PSIM1 slot and the microSD card into the TF/uSD slot, in the direction shown.

3

Connect the Terminal

Connect the terminal to your network, computer, or peripheral device as required.

1

Connect to the network

Connect the Ethernet cable to the terminal's LAN port and plug the other end into a network wall jack.

2

Connect to a computer

Connect the terminal to a computer using the serial cable.

3

Connect a peripheral device

Connect a peripheral device, such as a PIN pad, to the terminal using the USB-A adapter cable.

4

Connect the Power Supply

1

Connect the power cable

Connect the power cable to the terminal's power port, then plug the power adapter into a wall outlet.

2

Replace the back cover

Slide the back cover back onto the terminal until it clicks into place.

5

Load the Paper Roll

1

Insert the paper roll

Open the printer cover, insert the paper roll with the paper feeding out from underneath toward the front (A), press the roll into place (B), and close the cover (C).

2

Tear off the excess paper

Pull the excess paper upward against the serrated edge to tear it off.

6

Take a Payment

1

Swipe a card

Swipe the card through the magnetic stripe reader at the top of the terminal.

2

Tap a card

Tap the card on the contactless reader above the screen.

3

Insert a chip card

Insert a chip card into the card slot at the front of the terminal, chip first and facing up.

Full Installation Guide

For full device setup details, product information, and troubleshooting steps, refer to the T650c Installation Guide, available on the Verifone product documentation portal.

PreviousTroubleshooting Guidelines
NextT650t

Last updated

Was this helpful?