Ctrlk
RegisterLogin
For the complete documentation index, see llms.txt. This page is also available as Markdown.

V660c Quick Installation Guide

This guide walks you through unpacking, cabling and powering the V660c smart terminal and its base, loading receipt paper, and taking your first payment.

Before you begin, confirm you have all devices, cables, and accessories listed below.

What's in the Box

Cover

V660c Terminal

The handheld smart terminal with touchscreen, card reader and built-in printer.

Cover

Paper Roll

Thermal receipt paper for the terminal's printer.

Cover

Power Supply

Power adapter and cable for the communication base.

Quick Setup Guide

1

Insert the SAM and microSD Cards

1

Release the base cover

Press down on the catch on the underside of the base to release the cover.

2

Slide the cover off

Slide the cover away from the base in the direction of the arrow to expose the card slots and connector bay.

3

Fit the SAM and microSD cards

Slide each card into its slot in the direction shown: PSAM-1 and the microSD card in the lower carrier, PSAM-2 in the upper carrier.

2

Connect the Base

1

Connect the base to your network

Plug an Ethernet cable into the network port in the base's connector bay and connect the other end to your network wall socket.

2

Connect the base to the POS

Plug the serial cable into the second port in the connector bay and connect the other end to the POS or computer.

3

Connect a USB peripheral

Plug the peripheral's cable into the device, then into the USB-A port in the base's connector bay.

3

Connect the Power Supply

1

Plug in the power supply

Plug the power connector into the power port in the base's connector bay, then plug the adapter into a wall outlet.

2

Refit the cover

Route the cables out through the channel in the base and slide the cover back on until it clicks into place.

4

Load the Paper Roll

1

Open the printer and fit the roll

Pull the printer cover open (A), drop the paper roll in so the paper feeds from underneath (B), then close the cover (C).

2

Pull the paper through

Leave a short length of paper outside the slot and pull it upward against the tear bar to trim the excess.

5

Take a Payment

1

Swipe a magnetic stripe card

Swipe the card through the reader along the top edge of the terminal, in either direction.

2

Tap a contactless card

Hold the contactless card flat over the terminal's display until it is read.

3

Insert a chip card

Insert the chip card, chip first and face up, into the slot at the front of the terminal and leave it in place until the transaction finishes.

Full Installation Guide

For full device setup details, product information, and troubleshooting steps, refer to the V660c Installation Guide.

PreviousV660c
NextPrevious Models

Last updated

Was this helpful?