Before connecting the iOrder Food Service Kiosk, the Site Controller, POS terminals and router must be installed.
Remove the rear panel cover from the Ruby2 iOrder by pinching the tabs on each side at the bottom and lifting up.
First, plug the UPS into a 110v wall outlet, and then plug the DC power cord from the Ruby2 iOrder into an outlet on the UPS.
Connect the Ethernet cable from the Ethernet port on the Ruby2 iOrder to the router.
If orders are to be sent to a Kitchen Printer, then connect a RS-232 cable to the COM2 port.
If orders are to be sent to a Kitchen Display System (KDS), only the Kiosk's Confirmation Printer is required at the Ruby2 iOrder.
Connect the RS-232 cable to the COM3 port, then connect to the Confirmation Printer.
Replace the rear panel cover to protect the cables.
Last updated 1 month ago
Was this helpful?
