Ctrlk
RegisterLogin
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Victa Register Quick Installation Guide

Use this guide to unbox, identify, and set up Victa Register and Victa Lane.

Before you begin, confirm you have all devices, cables, and accessories listed below.

What's in the Box

Cover

Victa Register Device

Cover

48W PSU

*varies by country

Cover

SIM Ejector PIN

Cover

Green Dongle

Cover

Pedestal Blanking Cover

Cover

Victa Lane Countertop Base

Cover

Victa Lane Base Cable and Green Connector Cable

Device Walkthrough

Rear

1

Victa POS Volume Button

2

Power/ + Power Indicator

3

SIM / micro-SD Tray

4

SAM Tray

5

Audio Jack

6

Power/Navigator

7

Victa Lane Volume Button

8

Victa Lane Release Button

Front

1

Biometrics Cameras and Sensors

2

MSR Slot

3

Contactless

4

Protective sticker

5

EMV Reader

6

Speaker

7

Barcode Scanning

Base

1

Pedestal Cable Management

2

USB-C Port (Power)

3

USB-A Port (Peripherals)

4

USB-C Port (Split Screen)

5

Nonslip Grips

6

Countertop Screw Mounts

7

Cable Holders

Quick Setup Guide

1

Insert SIM/SAM/SD for Victa Lane

Locate the SIM/SAM ejector slot on the Victa Lane and use the SIM ejector pin to remove the tray.

When Victa Lane is used with Victa Register, only SAM is supported.

2

Insert SIM/SAM/SD for Victa Register

Locate the SIM/SAM ejector slot on the Victa Register and eject the tray.

3

Connect to Power

4

Connect to Power through Green dongle

5

Connect to Peripherals through Green Dongle

6

Connect to Peripherals Directly

Use direct power connection when the built-in port is sufficient to connect the peripherals.

7

Victa Register – Victa Lane Split Screen

1

Press and hold the release button

2

Once button is released, then slide the Victa Lane downward

3

Separate the Victa Lane from the Register.

4

Connect the Victa Lane base cable to to the Victa Lane

5

Place the Victa Lane on the countertop base, slide it down and pull it up until it locks into place.

6

Connect the other end of the cable to the Victa Register

7

Position the pedestal blanking cover over the opening and press it into place

8

Payment Methods

EMV Chip / Contactless (CTLS) / Magnetic Stripe

9

Barcode/QR Code Scanning

Present the barcode or QR code to the scanner window underneath, on the left-side of the Victa Lane.

Full Installation Guide

For full device setup details, product information, and troubleshooting steps, refer to the Installation Guide.

VPN: DOC573-014-ENG-A, Rev A00

PreviousTroubleshooting Guidelines
NextVicta Mini PINpad

Last updated

Was this helpful?