Network Test Failed
What to do when your P400 Two-Piece shows Network test failed, contact support with a red cross.
Symptoms
You may see one or more of the following:
A red cross with the message "Network test failed, contact support".
Payments are rejected or won't go through.
Why this happens: your terminal couldn't reach our payment system during the network test. This is usually because its internet connection has dropped, or its network settings don't match the connection you're using.
Before you start
This guide is for the customer unit — the unit your customer uses to pay.
To open the menu on the customer unit, press 4 and 6 at the same time, then enter password 1234.
Resolution
Check your terminal is online
Open the menu.
Select Administration > Settings > Communications.
Look for LAN or Wi-Fi showing as UP.
If one shows UP: your terminal is online — note which one it is, then continue to Step 2.
If neither shows UP: your terminal is offline. Reconnect it using How to Connect the Cables (network cable) or How to Set Up Wi-Fi (Wi-Fi), then continue to Step 2.
Check the Network Fallback setting
This setting tells your terminal which connection to use. If it doesn't match the connection you're using, the terminal can't reach our system — even when it's online.
Open the menu.
Select Administration > Settings > Network Fallback.
Select Default and make sure the connection you're using is ticked:
Ethernet if your terminal uses a network cable.
Wi-Fi if your terminal uses Wi-Fi.
Press the yellow back arrow key.
Select Fallback 1 and make sure None is ticked.
Press the red button until you're out of the menu.
Run the network test again
Run a network test to check the connection is now working — see How to Do a Network Test.
If the test passes: continue to Step 4.
If the test fails again: continue to Step 5.
If the network test passes and payments go through. Your terminal is ready to use.
If the network test still fails. Contact Support below.
Still not working?
Was this helpful?
